Sorted it! There was a broken wire to the plug, completely corroded through, just underneath the rubber shroud on the back of the plug. That loom costs about 90 quid so I just soldered the wire back together.
Now it can be mot'd - will probably fail on something else!
Hi all, just changed the front discs and pads and now this warning light has come on. Ive tried new pad wear sensors and checked the voltage at the plug where the sensor goes - this is only 7 volts - is this my problem?
All lights off now! Had to do a system function test after recoding the abs module and was about to follow the instructions on ross tech wiki, but the abs light went out after a few hundred metres and a right turn!
So pleased.
Thanks again to all those who replied. This has been a bit of a journey
Think Ive managed to recode the steering wheel module, but the abs module is still showing and error-
Control module incorrectly coded.
The software coding is currently 00000, but I cant change it without the login code, which I dont know.
Help please
Just checked this on my car and there is an open circuit - got a dtc and flashing glowplug light. If I get a suitable resistor and pop it into the plug will that fool the ecu into thinking all is well?
Too right. Had a major battle getting the airbag module bolted back in - one of the little screws stripped the first couple of threads and would not engage.
Just put the new module on and fired her up. Now got a flashing red brake warning light and steady amber abs light! As well as the esp and flashing glowplug.
Hope these disappear when we code the steering module.
Thanks for that.
Have ordered an F type module without cruise.
I suppose once I code everything and the body module (?) realises it doesnt have cruise it should be ok.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.