Recent content by FOX1980

Hi everyone, I have got a Q5 2021 model and was wondering whether it would be possible to retrofit the colour changing ambient lighting pack? I have seen a few chinese vendors selling the equipment but no one else.

I did not want to screw into the bodywork, as my 4D plate is thicker than normal I dont think the number plate surrounds will work.

Although this is an S4 the Q5 is similar, the area is covered by a foam pad, the fixing points are raised so if I tried to stick it on it would not make enough contact with the surrounding area.

The problem I have is the fixing points in the car stick up, I do not have a flat surface to stick to.

Hi, I have purchased new 4D plates for my Q5 and the vehicle fixing points both clash with letters, is there a mounting bracket available like the US ones that screw to the existing points? I do not want to rely on sticky pads alone. Any help would be appreciated.

Yes mate as said the wires are to send a positive feed to the inner lights off the number plate light so the led rings light up with side lights on. Just solder and heat shrink to number plate wire try not to cut it just use a knife to remove an inch of insulation.

Thanks mate, thanks also for everyones advice.

Managed to remove the nut by parking close to my house and using a jack to hold the breaker bar on the nut and turn

the bolts are the standard ones and they do appear to have a ring around the inner part

do you mean hammer a socket over the external diameter of the locking bolt?

Thanks for the replies will call my garage tomorrow to see what they can do, mine are genuine audi wheels nuts that came with the car

Hi all, as the title says im after some advice, I have a puncture and was going to put spare on only to discover the splines in the locking bolt itself are damaged so the key wont grip to turn, has anyone got a possible solution?. The key is fine and removes the locking bolts on the other three...

Maybe the parcel shelf, mine is terrible for it.

will the new a3 8v air vents fit an 8p?

you have put the warning light led for the door in there, look at the leds and you will see its white when switched off as the other is yellowish