Recent content by Final 3Green Land

Does no one have any advice or experience on these vehicles??

Hi, I'm posting for a mate as he isn't getting much help elsewhere... I'm looking to purchase a VW Touareg 3.0 Tdi from 2007 onwards or an Audi Q7 3.0 Tdi of 2007 onwards... preferably the 235+ bhp versions... I don't want anything newer than 2014 one due to price, and two, the other the...

Been with Flux for five years... No changes to my circs, and this year one car had more than doubled in price, the other was just under double, and when I spoke to them about it, as they claim to beat any quote, the obstinate CSA just said ''well we don't have to beat ANY quote'' 20 minutes...

Got a B6 1.9 TDi Turbo Quattro Sport Avant... Any good?

I visited an Aero Engineering firm local to me at the time and acquired a few lengths of I think 3/4in aluminium flat section bars and made my own. Total cost about £30 for a reasonable bottle of plonk!!

Well, again, I have managed to get to the correct answer... The brown earth wire can be disregarded completely. The resistor of 4.7 ohm is then connected between the two wires in the yellow connector. I soldered the resistor to these two wires, then insulated them leaving the connector...

That wasnt my question but I do.... The thing I need is advice on which of the three wires are bridged by the resistors?? The wiring colours appear different from most other posts on here... And, just in case you were wondering, the battery has been disconnected from the beginning of the...

Hi, I have an A4 TDi of 1998 vintage that I have temporarily swapped, the front seats whilst my originals are being refurbished... My queries is, which two wires do I connect the resistor to, to allow for the Airbag light to be extinguished. There are three wires, a brown... A white with a...

Erwin isn't an option due to cost and from past experience unreliability of information relating to particular models.... However, I went and did the job yesterday and found that if you used a plastic trim removal tool on the back of the hinge, the outer edge, and put pressure on the...

Hi, I have been asked to fit a front and rear facing dashcams for a customer on a 2016 A6 3.0TDi Avant Allroad. Can anyone shed any light on how to remove the trim surrounding the top of the tailgate so I can feed the wires for the rear window mounted cam through the wiring channel and then...

Pikkies above!! :hubbahubba:

Say hello to Hamilton.....

Best question could be... what make and where did you get them from.... and did they fit without adapting the Hub??

I keep taking them but as fast as I press the shutter, the car has gone!!! :welcoming: I have a few somewhere, I will look this weekend and try and put them up on here... But I have had so many comments on how sneaky it looks and sometimes when the other cars catch up, (if they can) how...

Its been a long project but its been worth it... basically its as below.... A4 Avant, Black, De badged, RS Grill, TQS Leather, RNS-E, FL Hid Conversions, Booooost gauge, Coilovers, Vented and Grooved 312mm discs, 235/40/18 Nokian Zlines on RS4 9 spokes... Strut Brace. AFN, BV43 Turbo, .280...