Recent content by bx3m

That might actually be an issue. My car also has the dieselgate software installed, so perhaps this is the reason why I also cannot adjust this value...

@20v-quattro - any news on the EGR adjustment?

Hi! I have the opposite problem - hot on driver side and cold on passenger side. From what I found online so far, it turns out that for your problem it usually is this valve at fault, the code for it is 8E0 820 036 and can be replaced rather easily, it is located right next to the air intake on...

Hey guys, similiar issue here. Let me tell you my story... I noticed last winter that the car heats up rather slowly. Why tf would it do that since it has the supplementary heater and whatnot... OK, winter passes, I console myself that this is the case with it and that's that, that is the way it...

Yes, I mean fuel consumption, but by 2% I mean that it went down from ~9% to 7%, during the 98% same driving conditions - I drive every day on the same route to/from work, at the same times, and the driving conditions are "the same". No, there is no limp mode active, it's just that after the...

Anyone know how to reset the IMRC? Or Perhaps the EGR needs a reset of adaptations? How do I do it? Both VCDS and OBD11... :(

Guys, what the hell did I do? After a few days when all went perfect, couple of days ago I plugged in the OBD11 and let the IMRC open/close run for a few seconds. Now, the consumption went back to as it was before the cleanup :( I tried to disconnect and reconnect the plug on it, same result...

Hey fellas! Soooo... I had the car at the repair shop the other day, for something else, but taking advantage of this, I asked the guys to also clean the swirl flap.... Oh My God!! It is truly the difference between day and night! The car is quieter, faster in response and I'm not sure about...

How about this one: https://wakaa.store/products/apple-carplay-android-auto-mmi-prime-kit-for-audi I've had one on my A6, worked quite well, easy to install. Uninstalled because I don't really use it...

Hey guys, I tried to do it earlier, but no luck. First, I was afraid to get this one loose: Next, I was unable to unscrew the 2 torx the hold the plastic from below... Any ideas on HOW to unscrew them? Also, is it safe to loose this metal bracket? Everything else went fine, even the lower back...

Thanks for the encouragement! I can imagine it's not a farmacy, especially since I have many town trips. Will definitely do it, but maybe not this week, I have just a couple of (full) days then going on vacation for a week. Will be back to post my impressions ;)

Hey! Got the same engine, found this topic and thinking of doing the same, even though I don't have any of your symptons, but just as preventive work. Any special issues during the process? Why did you remove the flap entirely?

Cool, I'll try that, thanks!

Is there any specific procedure about the driving after the reset?

Hey guys, Does any of you know how to find the exact gearbox I have on the car? I have a log that says: Address 02: Auto Trans (J217) Labels:| 0BK-927-156.clb Part No SW: 4G0 997 749 B HW: 0BK 927 156 AM Component: 0BK 30RTDIRdW H16 1001 Revision: --H16--- Coding...