For the bolts if it goes in OK and stops 1/4" from the bottom is strange. Normally threads go near the beginning. Check hole is clear (torch).
When I had my Vw R32 I cut the centre out of the holder and a smash repairer plastic welded it back together :)
Did you try an VCDS reset?
Plenty of 2 din GPS headunits on ebay etc.
I have fitted a few, On A3 (S3) Ive fitted Audiosources(winCe6) and Erisin (Android). Both plug and...
Ive fitted 4. Normally they are direct plug into the canbus socket, no wires to cut.
What happened to yours?
A lot more detail required.
New tyres with high pressure, now worn and lost air??
What year is an 59 plate?
I have it on my 2011
Takes a bit more if you change the filter.
As long as the old oil wasn't too discolored it should be fine, same fro rear diff.
If its from forward to rev its prob brake pads.
if its on slowing down and DSG box some make a slight noise on down change (like a motor bike...
On mine the screw behind the black caps were loose. Tightening fixed the droop.
Sadly we don't use that engine in the S3p's :frown new:
I removed the 2 side spring plates and put a piece of soft rubber on the bottom slides.
Fits well now.
Factory code to enter hidden settings under...
I purchased this
It should NOT leak when you push the pads in.
Also when you did the rear did you have the piston wind in tool?
Separate names with a comma.