Recent content by Audi.Quattro

VW wheel nut cap removal tool. Also when using, make sure its not too cold, be brave and one strong yank/pull will do it.

covers come of easy with the right tool. VW's have a tool that pulls off wheel bolt caps, they have a hole on the middle of them.. The same tool is also used to pull off the fog surrounds. Its a essentally a thick wire letter "P" with a hook on the end, loads on fleabay

I found the SC3's rather useless for grip under 5C, very easy to step the rear out. Winter tyres are the real answer, but they still seem to be an enthusiast only thing in the UK.

Thought I said it was NOT the pedal position.

It was more so, the lump sticking out the gearbox tunnel than the actual pedal locations that made my left leg hurt.

One of the reasons I had to get another car.

Apart from the door mirrors being attached to the door skin and two extra creases in the bonnet, it looks prettty much the same as a B8.5 to me.

If you love the look of dust and static attraction of it that you get with shiney black plastic? you will love the piano black, I hated it......

33psi in rears

Loads of threads on this, I've commented on loads of them myself. Basically the electric steering is c***, but you can reduce the effect somewhat. It also seems some cars are more affected by it than others, my car was very, very sensitive to tyre pressures. So start with pressurse, the Audi...

I'm still on Briskoda, mytiguan.com is the place for Tigs. If only the Audi sales guy's in Swindon would have looked after me like the service department have "they been very good", I would be in a Q5 now, that said I'm in love with this Tiguan

Collected the R-line Thursday :chuncky:, the Quattro has now gone :confusion: I hope to stay on here though, if its ok?

Just some more ref. I just hit 19k (minus max of @5k for winter tyres) they are Conti SC3's and have been rotated front to rear and they are all now @3.5mm, all evenly worn I might add. (my pressures must be correct) I estimate they will make another 3k miles, so @17k for the set on a...

I think the clue is in the title, "bore size". Its only the wheel that gets bored, if the bore size of the wheel is 66.6mm the flange on the hub will have to be a "fraction" smaller, and it will have a dimension but it's not a bore size. The workshop should would work it out from the adaptor...

Oh yeah, got that turned off too. Disable Windscreen Wiper “after wipe” 1. 09 - Cent Electrics 2. 07 – Coding 3. Select “x** 8K1 955 119 ** WWS xxxx” in top drop-down box 4. Long coding helper 5. Byte 1 6. Un-check box “Tear Wiping Active”