Recent content by Amir

  1. Amir

    Need some help with stripping out the interior

    Already done along with some of the door seals. The best way is for me to physically see where the water actually enters in from and then take action.
  2. Amir

    Need some help with stripping out the interior

    Very helpful. I'll probably strip the lot and see if I can trace my water leak at the same time. I'll update the thread once I've got the job done but thanks again for all your replies.
  3. Amir

    Need some help with stripping out the interior

    All the power cable has been run as per the above pic - in total 3 runs of 0 gauge, just some minor wiring needs doing alongside replacing a dodgy pair of RCAs which seem to be inducing some noise.
  4. Amir

    Need some help with stripping out the interior

    I have two aftermarket premium AGM batteries in the back with one up front but more importantly I have dual alternators up front that can produce around 500a of power on demand; more than enough ;)
  5. Amir

    Need some help with stripping out the interior

    Thanks for your reply. The only part I was worrying about was routing the wires at the front end but after some reflection I don't think it will be that hard. I will be getting a copy of elsawin anyway just for reference and I'm sure it will make things a little easier in the future too. As for...
  6. Amir

    Need some help with stripping out the interior

    Evening, I have a B6 A4 Avant, I need to install some RCAs and rearrange some other aftermarket wiring that runs from the front of the car to the rear. As it currently stands I think the most vacant side of the car is the drivers side, I already have quite a few runs of power and ground wire...
  7. Amir

    How many miles do you get out of you A4 1.9TDi??

    Thanks for the information, I will most definitely look into some Diesel Rhino :) .. I had an issue where my temperature wouldn't reach 90degrees, was stuck at 70, a thermostat change has fixed that since. I've been calculating my MPG based on the computer displaying 10miles remaining...
  8. Amir

    How many miles do you get out of you A4 1.9TDi??

    I thought I'd monitor my MPG as I'm not fortunate enough to have the MPG display like some of the SE members on here. The last time I posted my mpg was in 2009 when I first purchased my 1.9TDi I said I was getting 35mpg. I filled up £20.01 @ Shell (Vpower) 13.62 liters purchased @ 1.469, it...
  9. Amir

    Noise when clutch pressed in

    Yes Its in neutral when clutch is in making the noise and in gear also .. The sound is different sometimes a chirping sound, can also be like a bag of coins sound and sometimes its deeper.
  10. Amir

    Rear passenger floor SOAKED and front slightly damp!?

    @ Turkster - No. @ 666markyboy - as far as I know its the original cover this hasn't been replaced or removed. Once the car goes into the body shop for a few jobs the guy will take a look. @ L7AUDI - I thought this at first, however it isn't this been checked for it. I don't use the rear wiper...
  11. Amir

    Side skirt same as B7 model?

    The price is for a single side, a pair on ebay would cost 100+ the possibility of it being the wrong part and damaged in transit wasn't worth the small saving. Its not pre-painted. I was surprised they had 1 available on the shelf for me. Just to note the sideskirt is 2 parts.. As I only needed...
  12. Amir

    Side skirt same as B7 model?

    I just got the part from dealership worked out to be same price as ebay secondhand. Happy with that. 66quid inc vat
  13. Amir

    Noise when clutch pressed in

    Morning guys.. I had my clutch + flywheel replaced with a new LUK clutch and DMF over 7k miles ago. This was in july 2010, since then I had a sound when pressing the clutch pedal in. I took it back to the garage who had a look at it for a day and came back to say nothing was wrong...
  14. Amir

    Side skirt same as B7 model?

    Thank you mate
  15. Amir

    Rear passenger floor SOAKED and front slightly damp!?

    It is indeed after the padding was squeezed. Pollen filter housing checked over twice mate. Once I get to the bottom of this problem I will post culprit.