Recent content by a31.6sport

Hi have the same problem got it regassed and e on goes off i did have pressure sensor before regass so could that stil be the issue it’s not coming back as a fault since regarss jsit not cold i do have fault recirc flap Sent from my iPhone using Tapatalk

so on the 1.9 3 door what do i need to fit to upgrade to match the 345 s i have on front please Sent from my iPhone using Tapatalk

oh yous is left hand my bad lol Sent from my iPhone using Tapatalk

i got this loom bare in mind it’s for left hand so just be careful wiring up as mine worked the opposite seats lol Sent from my iPhone using Tapatalk

hi the photos are not working on the how too can you advise Sent from my iPhone using Tapatalk

hi mate have you done the honeycomb build grill for s3 from rs6 please

If anyone need s a unit with heated seats I ave one for sale as I've bought 2 just in case but there both fine and only need one

Ok mate maybe they revised it the problem I'm having is the seats just go hot and I have no control so I'm going to check again I've actually got original heated seat unit plugs that I got with the seats and the unit so I can hopefully cross reference hopefully lol

Sorry for the predictive text lol they said if d plug pin2 is present connect the grey wires that are also connected together to it each wire says something t15 and then a number 10.9.5.6 and so on 13 and 14 had labels attached so they where Easy identified

Hmmm ok I've had kufatec on the phone and they where telling me the numbers on the wires relate to the PIN numbers to connect to and the one that as you said is connected together connect s to d plug pin 2 if there is a wire present solder it so this is where I'm getting Confused

How did you identify them to go where and are the pins Easy to come out once the in to swap around

If you can just about see

Hmmm ok on the grey wires there are numbers but how dos you identify them They way kufatec said is the bunper on wire refers to the pun Red/ White – Steady plus - Fusebox Wires (Gray) on the opposite needs to be connect to the climate control Connector D PIN 13, 14 Manual wiring heated seats...

I'm currently doing this are you saying the instructions from kufatec are wrong as all my wires are grey on the end that goes into control unit