Comfort Control Power Supply Unit
- Thread starter Monzta
- Start date
SemedoB6
Black and white a4
It shouldn't be. But that's not the comfort module. Comfort module is under passenger seat.
That's centre electronics module.
Sent from my SM-N960F using Tapatalk
That's centre electronics module.
Sent from my SM-N960F using Tapatalk
Thanks for that @SemedoB6 .
That explains a lot. I've watched what seems like hundreds of videos where many seem to refer to both boxes by pretty much the same or similar names.
Out of interest, do you think the centre electronics module that's had water ingress could cause the front wipers to stop working?
That explains a lot. I've watched what seems like hundreds of videos where many seem to refer to both boxes by pretty much the same or similar names.
Out of interest, do you think the centre electronics module that's had water ingress could cause the front wipers to stop working?
SemedoB6
Black and white a4
Happy to help pal.
No idea on that. Might even be a faulty wiper mechanism. But I'm just guessing.
Sent from my SM-N960F using Tapatalk
I've replaced the wiper motor and the linkage but still nothing, no power is getting to the motor. The wipers going on the fritz does coincide with water getting into the CEM though. And the fuse is fine.
SemedoB6
Black and white a4
Maybe it's the module then.
Have a look on ebay. You might find a direct replacement cheap.
Sent from my SM-N960F using Tapatalk
My new centre electronics module arrived today so I fitted it and now have not only working wipers but the engine starts and doesn't stall within a few seconds. So a good result all round.
Just in case water ever found it's way in again I fitted some clear sticky plastic film (my daughter uses it to cover her school books) to the top side of the module to stop the water getting into the case. There's no cooling vents on it so guess it's OK to do this.
Now I have an error code saying '01794 - Control Module - Incorrect Chassis (VIN) Number' so need to work out how to change this on VCDS. A job for later in the week.
Just in case water ever found it's way in again I fitted some clear sticky plastic film (my daughter uses it to cover her school books) to the top side of the module to stop the water getting into the case. There's no cooling vents on it so guess it's OK to do this.
Now I have an error code saying '01794 - Control Module - Incorrect Chassis (VIN) Number' so need to work out how to change this on VCDS. A job for later in the week.
SemedoB6
Black and white a4
That's an easy fix.
Go into adaptation channel 081 and wait for the pop up window with a code. Type the code into new value field, test and save.
Clear code and this should match the new part to your car's vin number.
It's been a while since I've done this. But I'm pretty sure that's the procedure to get rid of that code.
But if u ou can't that's nothing to worry about because it won't keep it from performing like it should..
Sent from my SM-N960F using Tapatalk
Go into adaptation channel 081 and wait for the pop up window with a code. Type the code into new value field, test and save.
Clear code and this should match the new part to your car's vin number.
It's been a while since I've done this. But I'm pretty sure that's the procedure to get rid of that code.
But if u ou can't that's nothing to worry about because it won't keep it from performing like it should..
Sent from my SM-N960F using Tapatalk
SemedoB6
Black and white a4
Good stuff.. Glad to know I still remember how to do it.
Sent from my SM-N960F using Tapatalk
Sent from my SM-N960F using Tapatalk
