Audi B5 1.8se

[tony birch]

Hi wondering if you guys could help ,looking to buy a S4 milltek rear exhaust box and fit it to my 1.8se avant 2000.
its off a saloon S4
question will it fit on the hangers I will get the pipe work behind sorted to go into my original system .

Thanks tony

 

[Rfmacaskill]

I had a custom exhaust made for my B5 TQS saloon which I then transferred to my S4 Avant...so yes it should be a straight swap over.


Sent from my iPhone using Tapatalk

 

[tony birch]

Ok thanks ,the worry I have is the Quattro to fwd ,your was Quattro to Quattro. Floorplan boot spare wheel well .Its only £80 so might just buy it and see.
Cheers

 

[Rfmacaskill]

Good point...I’d imagine the Quattro tunnel is a good bit wider to accommodate both the driveshaft and exhaust.

Good luck!


Sent from my iPhone using Tapatalk

 

[Avant1]

Good point...I’d imagine the Quattro tunnel is a good bit wider to accommodate both the driveshaft and exhaust.

Good luck!


Sent from my iPhone using Tapatalk

The fuel tanks are different too


Sent from my iPhone using Tapatalk

 

[aragorn]

Quattro exhaust is completely different to a FWD car.

The FWD exhuast loops up over the rear axle, and has its mid silencer on the drivers side.

The quattro exhaust goes under the subframe and has its mid silencer on the passenger side.

Even the backbox itself sits much further rearwards on a quattro car. Its all just completely different.