Looking at fitting a fibreglass replica RS4 bumper. whats the best route forward to adhere the bumper to the steel bar as per this photo? any good bonding agents or glues?
Bonding agent/adhesive
- Thread starter Arrkon
- Start date
- Joined
- Nov 24, 2010
- Messages
- 15,084
- Reaction score
- 1,131
- Points
- 113
- Location
- Plymouth
- Website
- wheelsnwires.blogspot.com
Why not get a Rieger or something like this First Ever RSR A4/S4 B5 Front Bumper Sale :: LLTek Motorsports
Had the offer of an rs4 fibreglass replica for cheap. But think he's sold it now
so this may be a dead end. To be honest. I wanted an s4 bumper ideally, to fit a FMIC yet stay subtle, but they seem to be rare as rocking horse poo to come up for sale or rediculously expensive... £300+ 2nd hand!!!!
Last edited:
Had the offer of an rs4 fibreglass replica for cheap. But think he's sold it now
Exactly the same boat mate lol
tigerseal is very sticky and strong but it is not what I would call an adhesive, it is more a sealant compound.
its very thick and dense and unless very warm is difficult to get into a thin layer.
its very thick and dense and unless very warm is difficult to get into a thin layer.
Foxmeister
Fired Up!
Tiger Seal is good stuff, seals aswell as sticks!!!
Depends on the bumper also, the Dietrich one i had already had 2 mounts fitted to mount the Audi bar onto.
Depends on the bumper also, the Dietrich one i had already had 2 mounts fitted to mount the Audi bar onto.
phoenixv6quattro
staylowmovefast
Sikaflex 252. This is what held my rear bumper Votex attachment on and my sideskirts for about, ohhhhhhh, oh dunno 2 years? ****** excellent stuff. It was also used to pack out my rear diff mount and gearbox mounts for an extra rigid ride. Cant reccomend highly enough, but does take a while to set.
Had the offer of an rs4 fibreglass replica for cheap. But think he's sold it now
I believe Grizz will have an S4 bumper shortly that has been modded for FMIC
