Parking sensors

[swarcup]

Now Gents
Im after a bit of advice, Ive managed to aquire a rear bumper and valance from a 1.8tavant with the twin cut-outs and now its sat in my back garden it still has all 4 parking sensors and wiring in it. This got me thinking if i now fitted the whole thing and not just the lower bit, can the sytem be retrofitted? anyone know?

 

[scott b]

as far as i know, yes it can, but it aint cheap, hence why when i did this, i removed the standard audi ones and fitted laserline sensor kit, which just conects to the reverse wire and earth wire

 

[Garfie]

I briefly looked into this when I did my twin exhaust conversion. I didn't dig deep but I got the impression it was quite a bit of hassle (and cost) to retrofit the genuine sensor loom.

Hence why I went for Audi's aftermarket fit kit the Cobra Parkmaster A0158. Its the exact kit Audi supplies, just without the Audi branding on the box! Works perfectly too.

 

[Turkster]

Now Gents
Im after a bit of advice, Ive managed to aquire a rear bumper and valance from a 1.8tavant with the twin cut-outs and now its sat in my back garden it still has all 4 parking sensors and wiring in it. This got me thinking if i now fitted the whole thing and not just the lower bit, can the sytem be retrofitted? anyone know?

Dont do it, its a balls ache and expensive, just get the after market kit as advised,

 

[Woorlord]

Cobra kit is the sensible solution unless you have deep pockets!

 

[no_idea]

I have a set of 4 sensors, the control box, the wiring loom for the sensors into the car and the buzzer. All brand new genuine Audi in boxes if anyone is interested. If you need part numbers just shout.

 

[NHN]

Is that the aftermarket audi kit or the factory fit kit?

Pics & part numbers would be useful so we can distinguish them apart.

 

[no_idea]

Sorry, It is the factory fit bits. I will post some pictures when I get to work tomorrow with part numbers.

 

[no_idea]

Here are the pictures:

Obviously there are 4 of the sensors
I think all that is needed is the loom from the control box to the car wiring. Kufatec do these, I think this is the one KUFATEC GmbH - Kabelsatz PDC Steuergert - Zentralelektrik Audi A4 B6 33859

 

[scott b]

does it have the holders for the sensors aswell

if not i might have some old ones if anyone needs them

 

[no_idea]

No Scott there are no holders. If you have some it may help someone. Thank you. Did Audi do them, because when I was looking I couldnot see anything. I did find some Skoda ones that I thought were suitable but I cannot find the part number.

 

[scott b]

no worries, will have a look shortly and see if there are any part numbers on them

 

[scott b]

found them, only got 2 holders. no part numbers either

 

[will89]

I may be interested in those sensors. How much you looking for?

 

[no_idea]

I may be interested in those sensors. How much you looking for?

PM sent