1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Window motor fault codes

Discussion in 'VCDS (formerly VAG-COM) forum' started by KRL, Jan 6, 2008.

  1. KRL

    KRL Member

    Joined:
    Jul 13, 2007
    Messages:
    522
    Likes Received:
    1
    Hi,

    My car is showing the following faults agains the driver and passenger windows:

    42-Door Elect, Driver -- Status: Malfunction 0010
    52-Door Elect, Pass. -- Status: Malfunction 0010

    -------------------------------------------------------------------------------
    Address 42: Door Elect, Driver Labels: 8P0-959-801-MIN.LBL
    Part No: 8P0 959 801 H
    Component: Tuer-SG 020 0090
    Coding: 0000760
    Shop #: WSC 06435
    1 Fault Found:
    00932 - Electric Window Motor; Drivers Side (V147)
    005 - No or Incorrect Basic Setting / Adaptation - Intermittent
    -------------------------------------------------------------------------------

    -------------------------------------------------------------------------------
    Address 52: Door Elect, Pass. Labels: 8P0-959-802-MIN.LBL
    Part No: 8P0 959 802 H
    Component: Tuer-SG 020 0090
    Coding: 0000760
    Shop #: WSC 06435
    1 Fault Found:
    00933 - Electric Window Motor; Passenger Side (V148)
    005 - No or Incorrect Basic Setting / Adaptation - Intermittent
    -------------------------------------------------------------------------------

    Both widows are working ok. Does anyone have some further information on what these mean?

    Thanks in advance.
     
  2. Google AdSense Guest Advertisement



    to hide this advert.
  3. Gti Jazz Blue

    Gti Jazz Blue Active Member
    VCDS Map User

    Joined:
    Feb 26, 2007
    Messages:
    1,655
    Likes Received:
    7
    Battery been off recently ?

    I suspect that it is telling you that the once touch open / close needs to be calibrated.

    Hold the down until the window is full open then a few more seconds and then do the oposite.

    Make sure that the one touch operation works on both windows and then see if the codes have gone.

    Regards,

    Paul
     
  4. KRL

    KRL Member

    Joined:
    Jul 13, 2007
    Messages:
    522
    Likes Received:
    1
    Thanks, I'm pretty sure the one touch operation is working. I'll give it a go tomorrow.
     
  5. KRL

    KRL Member

    Joined:
    Jul 13, 2007
    Messages:
    522
    Likes Received:
    1
    Yep the one touch operation is working ok.
     

Share This Page