1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Who here is successfully running a forge split-r with no error codes on their AUM?

Discussion in 'A3/S3 Forum (8L Chassis)' started by FJ0372, Aug 7, 2012.

  1. FJ0372
    Offline

    FJ0372 New Member

    Joined:
    Jan 1, 2012
    Messages:
    22
    Likes Received:
    0
    [Aug 7, 2012]
    I'm not interested in another thread about the 007p being a better performance part or the car being intended for a recirc. rather than an atmos. I'm just interested to know whether the forge split-r can actually be run on an AUM without causing ECU errors/ running issues and at which hybrid setting this is possible on?

    Thanks in advance for all helpful replies.
    #1
  2. Ads

    Ads

    [Nov 29, 2014]

  3. <tuffty/>
    Offline

    <tuffty/> Badger 5 Edition Staff Member Moderator

    Joined:
    Sep 14, 2008
    Messages:
    16,322
    Likes Received:
    1,498
    [Aug 7, 2012]
    IMO No...

    Its no good as an atmos or a DV valve as its hugely compromised to make it what it is...

    While you may not be interested in the whole "the car being intended for a recirc. rather than an atmos" discussion the fatcs are on std management they will cause problems...

    There is no compelling reason to use the split-r over a recirc valve...

    <tuffty/>
    #2
  4. Yohan87
    Offline

    Yohan87 Member

    Joined:
    May 19, 2011
    Messages:
    413
    Likes Received:
    12
    [Aug 7, 2012]
    If the noise is what you are after, then you will easily achieve that with a Forge 007/008 valve and an open cone filter.
    #3
  5. kwistof
    Offline

    kwistof South East Events Moderator Regional Rep

    Joined:
    Jun 1, 2010
    Messages:
    2,342
    Likes Received:
    485
    [Aug 7, 2012]
    I'll hold my hands up and admit I ran a Split R on my first S3 for about 6 months and also my current one (APY) for over 9 months.......

    It didn't throw up the engine management light on either of the cars.

    My 1st S3 only had the Split R on..

    Whilst my current car S3 is running a B5 TIP, Large Cone filter, Re-map and 007P and I would say my current set up is now louder than how it was on my 1st S3 that was standard with just the Split R
    #4

Share This Page