Where is your rear adjustable tie arms?

[Reesy]

Dont worry jojo, dave has already contacted me.

Next question will be is it better to put the stainless tie-arm at the bottom and mild steel at the top?

as karl has chosen the most popular answer, I'd weigh them both and place the heaviest one on the bottom to keep the weight as low as possible

 

[*P3nfold*]

follOwed by the question, does it really ****ing matter

To be honest properly NOT but if I didn't ask I am sure someone else will!

I have already said to Dave I will take a set once I sell some of the parts off from the battered Golf (RIP), and settle up.

I've only ever come across mild steel in exhausts and was wondering. Also as Chris said, I could weight them but thats not really going to happen as time is tight and I need to finish the car by end of Feb, beginning of March.

 

[*P3nfold*]

as karl has chosen the most popular answer, I'd weigh them both and place the heaviest one on the bottom to keep the weight as low as possible

As always Chris your wisdom is deep lol. Good to see you last night at Prept.

 

[s3dave]

I've only ever come across mild steel in exhausts

Your car and chassis is made of mild steel....apart from the obvious....

 

[*P3nfold*]

Your car and chassis is made of mild steel....apart from the obvious....

Really, I never knew that lol. Still learning.