Separate names with a comma.
Discussion in 'Detailing - Sponsored by Slim's Detailing' started by vr6gordy, Jan 21, 2012.
any know whats the best type of pad to use when putting on poorboys black hole
Glaze or finishing pad
I use a hex logic finishing pad for my jetseal 109, and it's awesome. And easy to clean as well. Assuming you're using a DA.
Chemical Guys - Blue 5.5" Hex-Logic Pad ... think i got the wrong pad ordered ????????????? or will it be ok
The Blue Hex pad should be fine, its one of the softer pads they have. just remember when your finishing to use little to no pressure on the pad. Using a DA.
Personally i just rub it on with a soft applicator pad by hand, and then buff it off with a super soft blue buffing towl.
then dont forget to seal it in :-D
had a quick go with new pad today and wow its awesome
Personally I use the blue hex logic for glazes (non filler) and sealants rather than the black finishing pad as I prefer to use that for refining down.....looking good.
I love jetseal
jet seal is the king
+1 on that. Jetseal rocks! Especially with the hex logic pad. Looking good, nice pics.
water beedage ... took this pics this morning
mines still cobwebbed to death after the black hole propper gay. anyone want to do mine with a da if i suppiy the pads got the jetseal and black hole. i can provide cups of tea and sausage butties ?
How about coming up to an open day at ours and we could all have a go?
when you having an open day then ???????????
No definite dates at the minute but we had quite a few last year and they proved very popular....I'll get an interest thread up in the Juicy forum area
You'd be up for it?
When are where Jen would love too meet some of the members
think she be having it at her place of work
Check out the thread I've put up in the Juicy Detailing forum under Sponsors section