1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Wellycooler Help

IrishDave Oct 21, 2012

  1. IrishDave

    IrishDave Active Member

    682
    45
    28
    Ok I know quite a few people have fitted these to their cars. What I want to know is where did you relocate the horn to? and how. Did you use the normal bracket or make a new one up.
    Thanks.
     
  2. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow... Staff Member Moderator Audi S3

    20,847
    3,687
    113
  3. Sam_

    Sam_ Down under

    3,034
    478
    83
  4. Dani_B19

    Dani_B19 Audi-sports own special child.

    9,047
    337
    83
    Cable ties and some man power haha.
     
  5. coatesy

    coatesy poking badgers with spoons

    1,920
    280
    83
    Haha I was going to say man power, I have an a3 so I don't know how different it is on an s3
     
  6. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow... Staff Member Moderator Audi S3

    20,847
    3,687
    113
    They are... bracket is already under passenger side wing where the second SMIC would go on an S3

    <tuffty/>
     
  7. Paradox1

    Paradox1 Active Member

    1,833
    88
    38
    I just bent the bracket and fitted it back.its touching the intercooler pipe but it will be ok :)
     
  8. IrishDave

    IrishDave Active Member

    682
    45
    28
    Right thanks for that. Next problem. I am having an absolute nightmare trying to get the bumper back on. The cooler is sitting too low and because of the bracket on the drivers side where the old charge pipe mounts to it will not raise any higher. At the moment the pipes from the end tanks are sitting lower than the grilles and fogs. Any ideas. Pleassseeee
     
  9. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow... Staff Member Moderator Audi S3

    20,847
    3,687
    113
    Pics please...

    <tuffty/>
     
  10. Paradox1

    Paradox1 Active Member

    1,833
    88
    38
    You will have to butcher the inside of the bumper.try trial fitting it then seeing where it makes contact.its mostly the lower part that needs trimming.thetop should be fine.may have to.trim the vents down too.get a pic up
     

Share This Page