1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Washer Jets

Discussion in 'TT/TT-S/TT-RS Forum' started by Moro Anis, Mar 23, 2008.

  1. Moro Anis
    Offline

    Moro Anis New Member

    Joined:
    Feb 17, 2008
    Messages:
    13
    Likes Received:
    0
    [Mar 23, 2008]
    My screen washers seem too low. They hit the bottom of the screen and get masked by the wipers. I looked at them for adjustment but they seem llike a moulded plastic assembly. Is there any adjustment or are they designed into that position?
    #1
  2. Ads

    Ads

    [Nov 26, 2014]

  3. rabvtec
    Offline

    rabvtec New Member

    Joined:
    Nov 21, 2006
    Messages:
    2
    Likes Received:
    0
    [Mar 31, 2008]
    Hi

    Open the bonnet and if you look carefully, you'll see a screwdriver type slot in the side of the jet. This is where you adjust the level for your jets. Be CAREFUL though, as there is very little adjustment that can be made here .. :unsure:
    #2
  4. Moro Anis
    Offline

    Moro Anis New Member

    Joined:
    Feb 17, 2008
    Messages:
    13
    Likes Received:
    0
    [Mar 31, 2008]
    Hi,
    I found the slots you mention which are acually snail cam adjusters. Very posh but even with them adjusted,I still can't get enough angle to miss the wipers in the rest postion. I checked the wipers and they apper to be parked correctly on the screen. Someone suggested putting a pin in the jets and moving them but they look like a non adjustable moulding to me.
    #3

Share This Page