1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Votex rear fitment

Discussion in 'A4/A4 cabriolet/S4 forum(B6 chassis)' started by mattyb6, Feb 4, 2013.

  1. mattyb6

    mattyb6 Active Member

    Joined:
    Apr 19, 2012
    Messages:
    969
    Likes Received:
    75
    Bought myself a votex rear, with grilles etc
    but not sure how it attached to the car

    is it the same principle as the front, via tiger seal?
     
  2. Advert Guest Advertisement


  3. dpbayly

    dpbayly Member

    Joined:
    Oct 21, 2012
    Messages:
    391
    Likes Received:
    16
    Yes and screws in at the inner wheel arch where it wraps round, If its a genuine Votex then there is a small recess around the top edge of the inside of the skirt this is where you put the bonding agent
     
  4. mattyb6

    mattyb6 Active Member

    Joined:
    Apr 19, 2012
    Messages:
    969
    Likes Received:
    75
    I don't know if its genuine
    it seems very flimsy I'm going o do some test fits today
     
  5. mattyb6

    mattyb6 Active Member

    Joined:
    Apr 19, 2012
    Messages:
    969
    Likes Received:
    75
    Update: took it out for a quick test fit and seems to be fine, there is a small recess for the beading aaswell but can't find a audi stamp or part number etc anywhere
    but it does fit and I have all the grilles so all good in my eyes

    pics to follow when it's on
     

Share This Page