VCDS Auto Scan Log

[Dan-Jnr]

Chassis Type: 8L - Audi A3/S3
Scan: 01,02,03,08,15,16,17,22,35,37,45,55,56,57,75,76

-------------------------------------------------------------------------------
Address 01: Engine Labels: 06A-906-032-AJQ.LBL
Controller: 8N0 906 018 BH
Component: 1.8L R4/5VT 0001
Coding: 10710
Shop #: WSC 02629
VCID: 78836BE34BDD
WAUZZZ8L231203225 AUZ7Z0B2120923
1 Fault Found:
18010 - Power Supply Terminal 30: Voltage too Low
P1602 - 35-10 - - - Intermittent
Readiness: 0000 0000


-------------------------------------------------------------------------------
Address 03: ABS Brakes Labels: Redir Fail!
Controller: 8N0 907 379 E
Component: ESP 20 CAN V005
Coding: 18448
Shop #: WSC 01236
VCID: 3E0FBDFB2979
1 Fault Found:
00812 - Brake Pressure Release Solenoid (F84)
35-10 - - - Intermittent

 

[Dan-Jnr]

Any help with these fault codes would be appreciated.

 

[S3 Paul]

First is... one of a few...
Battery terminal has been off or... is loose
Battery is on its way out,

If you remove the battery the car will always log the low voltage code...
Second code im not so sure of,

I work by the rule... read the code, write it down. clear it from thr car and drive for a week or so then rescan , if the fault is back... worry, if not happy days

 

[s3dave]

As above on the first one..
the second one is usually a brake switch fault, do your brake lights work ok?
As paul said clear the faults (as they could be very old) and recheck after a drive/day or 2

 

[Dan-Jnr]

Thanks for the advise. My brake lights do work.
I'll clear the codes and re-check in a week.