1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

straight tailpipes on 1.9tdi exhaust

Discussion in 'A4/A4 cabriolet/S4 forum(B6 chassis)' started by munchkincoupe, Mar 16, 2013.

  1. munchkincoupe

    munchkincoupe Member

    Joined:
    Aug 21, 2010
    Messages:
    950
    Likes Received:
    19
    If I were to fit the twin cut out rear bumper valance onto my avant 1.9tdi is it a simple job to just fit straight tailpipe trims to my downturned tailpipes - obviously I would expect to cut some of the original pipe down

    Thanks
     
  2. Google AdSense Guest Advertisement



    to hide this advert.
  3. quattrojames

    quattrojames Moderator
    Staff Member Moderator Audi Avant Owner Group Audi A6

    Joined:
    Mar 28, 2008
    Messages:
    14,019
    Likes Received:
    532
    Yeh, most people just weld new tips onto the back boxes. Depending whether your 1.9 is quattro, you'll obviously only have tips one side unless you fit a 1.8T (or similar) system.
     
  4. munchkincoupe

    munchkincoupe Member

    Joined:
    Aug 21, 2010
    Messages:
    950
    Likes Received:
    19
    yes it's quattro - thanks
     
  5. Dan TheMan Welburn

    Joined:
    Jun 3, 2012
    Messages:
    461
    Likes Received:
    23
    Is it straightforward to put a twin exit system from a 1.9tdi Quattro if you only have the single (one sided) system as standard? I know the bolt holes etc are all there underneath for the mounts, but wasn't sure if the exhaust route would be a direct fit?
     

Share This Page