1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

S3 Clutch

Discussion in 'A3/S3 Forum (8L Chassis)' started by Dansmith, Jul 10, 2013.

  1. Dansmith

    Dansmith Member

    Joined:
    Apr 22, 2009
    Messages:
    461
    Likes Received:
    7
    Hey Guys, It's been a while!

    My S3 has finally got to the point that I have to replace the clutch. The car has a stage 2 revo remap and all the bits needed for this. the garage I am having it done at is worried that a standard clutch may go again rather quickly as its not beefy enough.

    I can't quite remember if I read on here thinking that the standard clutch was good upto 300bhp and thought I would ask for clarity!

    If upgrade recommended which clutch and where to buy?

    Thanks all and hope your well!

    Dan
     
  2. Advert Guest Advertisement


  3. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow...
    Staff Member Moderator Audi S3

    Joined:
    Sep 14, 2008
    Messages:
    19,729
    Likes Received:
    3,147
    Std clutch is fine as long as you aren't launching it...

    <tuffty/>
     
  4. Rice

    Rice Active Member

    Joined:
    Oct 1, 2012
    Messages:
    247
    Likes Received:
    37
    Sorry to hijack the thread but do the bevel box seals need replacing when doing the clutch/flywheel?
     
  5. Dansmith

    Dansmith Member

    Joined:
    Apr 22, 2009
    Messages:
    461
    Likes Received:
    7
    Launching uses too much petrol So standard clutch it is! You still in the Beast Tuffty?

    Thanks
     
  6. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow...
    Staff Member Moderator Audi S3

    Joined:
    Sep 14, 2008
    Messages:
    19,729
    Likes Received:
    3,147
    Its advisable when removing the bevel box as part of dropping the box... while its possible to get the box out with it attached it is far less hassle to remove it first as it gets caught on the block... 02M boxes are heavy :)

    Don't forget you will need a special long allen key to undo the flange retaining bolt... just undoing the four large bolts won't separate the bevel box...

    Of course :)

    <tuffty/>
     
  7. Dansmith

    Dansmith Member

    Joined:
    Apr 22, 2009
    Messages:
    461
    Likes Received:
    7
    I will have to look through your build thread and see what you have been upto...

    I'm guessing flywheel is recommended to be changed at the same time as the clutch? I have ordered one just incase that can be sent back if I don't use it!
     
  8. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow...
    Staff Member Moderator Audi S3

    Joined:
    Sep 14, 2008
    Messages:
    19,729
    Likes Received:
    3,147
    Normally yeah... they 'say' its good for two clutches (typically original plus one change) before needing swapping but most I have seen are pretty fecked...

    <tuffty/>
     

Share This Page