1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  1. Jman

    Jman Member

    97
    0
    6
    Basically to integrated engineering to non drilled rods?
    And if you buy non drilled rods and they be drilled? and any one have a rough idea how much it would cost? Thanks
     
  2. Lewis583

    Lewis583 Active Member VCDS Map User

    956
    91
    28
    Yes they can be bought without rifle drilling, however it has been documented on here by Tuffty that non drilled rods caused premature wear on the gudgeon pins and little end bushes in his S3.

    It would be definitely be easier and likely cheaper to just buy them pre drilled mate. Bill@Badger5 is an Integrated Engineering importer/seller. Drop him a PM.

    Couldn't give you a cost to drill non-drilled rods as most people who want rifle drilled rods buy them pre-drilled.
     
  3. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow... Staff Member Moderator Audi S3

    20,344
    3,494
    113
    They are not drilled in the traditional way, its done using a form of wire erosion... it would potentially be far more expensive in the long run to buy non drilled rods and have them 'drilled'... do it right, do it once... :)

    <tuffty/>
     
  4. badger5

    badger5 www.badger5.co.uk Site Sponsor

    9,172
    1,790
    113
    not generally done.
    buy what you want ready done.. not try to find someone to do it afterwards

    EDM is the process used to make the oil hole to small end, aka rifle drilling.. aka wire erosion etc
     

Share This Page