1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Rear bumper removal?

Discussion in 'A4/S4 forum(B5 Chassis)' started by Foxmeister, Jul 20, 2009.

  1. Foxmeister
    Offline

    Foxmeister Fired Up!

    Joined:
    Apr 1, 2009
    Messages:
    1,779
    Likes Received:
    4
    Ok, located the main bolts in the boot that need removed under boot carpet, but at sides where bumper meets rear arches there seems to be another small piece of black splash guard on inner wheel arch, how is this removed as i dont see a fixing? This stops the bumper from being pulled backwards and off the car, any help?
    #1
  2. olds_kool
    Offline

    olds_kool Active Member

    Joined:
    Jul 21, 2007
    Messages:
    1,072
    Likes Received:
    4
    just swapped one today, it pulls out first of locating bracket then back
    get some gloves on and pull, its on very tight!!!!
    #2
  3. Foxmeister
    Offline

    Foxmeister Fired Up!

    Joined:
    Apr 1, 2009
    Messages:
    1,779
    Likes Received:
    4
    Cheers. Tried that the other day, but looked like bumper was gonna bend n crease, or break. So u mean, pull the 2 side sections away from car, left n right side? If so, how would it b re-installed if your pullin them out like that, push back into arch? I take it they must b clips of sum sort rather than guides/runners like most other cars?
    #3

Share This Page