1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Rear Axle Bushing Remover / Installer Tool

Discussion in 'A4/A4 cabriolet/S4 forum(B6 chassis)' started by Turbo_Boss, Feb 16, 2014.

  1. Turbo_Boss
    Offline

    Turbo_Boss New Member

    Joined:
    May 29, 2003
    Messages:
    8
    Likes Received:
    0
    [Feb 16, 2014]
    Hey Guys,

    I talked with my mechanic and he toll me that he dont have a Rear Axle Bushing Remover / Installer Tool

    He says if I can get the tool for him, he will not charge me anything.

    Since this is my mechanic that fix all the car in my family and I have a good friendship with him, I want to buy these tool and give them to him as a gift BUT dont want to spend too mu$h

    I was looking on the net for a Bushing removal tool and only find a tool that only is a installer but not removal.

    Can you guys let me know what inexpensive tool can do both jobs.

    THX,
    #1
  2. Ads

    Ads

    [Oct 24, 2014]

  3. dale86
    Offline

    dale86 Member

    Joined:
    Oct 29, 2012
    Messages:
    377
    Likes Received:
    9
    [Feb 16, 2014]
    I could be wrong mate but as for a Bush removal tool some people just normally burn them out if theyre just rubber .
    #2
  4. B5NUT
    Offline

    B5NUT Well-Known Member VCDS Map User

    Joined:
    Feb 6, 2010
    Messages:
    2,348
    Likes Received:
    267
    [Feb 16, 2014]
    I used an electric jigsaw to remove the old bushes, only takes a couple of minutes.
    #3
  5. JudderMan
    Online

    JudderMan Active Member

    Joined:
    Nov 29, 2012
    Messages:
    863
    Likes Received:
    124
    [Feb 16, 2014]
    I'm sure my mechanic guy that did mine just burnt them out with a torch and BFH.
    #4
  6. S3 GAZ
    Online

    S3 GAZ Member

    Joined:
    Dec 17, 2006
    Messages:
    364
    Likes Received:
    8
    [Feb 16, 2014]
    Hammer and chisel on my mk4 golf and a saw to cut through the metal casing.
    #5
  7. Mike.M
    Offline

    Mike.M Well-Known Member

    Joined:
    Oct 11, 2003
    Messages:
    1,742
    Likes Received:
    84
    [Feb 16, 2014]
    As above.....but go slow with the saw so not to damage the frame.
    #6

Share This Page