1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

nsr tyre wearing on the inside?

Paradox1 Nov 18, 2012

  1. Paradox1

    Paradox1 Well-Known Member

    1,833
    88
    48
    Noticed it when I got q nail taken out of my tyre.anyone know what it could be?I had my rear beam bushes replaced for powerflex bushes about a year ago but I'm not sure what it causing it.anyone had this?
     
  2. jacks3

    jacks3 New Member

    18
    0
    1
    Your car properly needs a alignment.
    Once the wear has started you cannot stop it, you would be best putting 2 new tyres on the axle then finding your local garage with a Hunter alignment machine then they can Set you car up to manufacture spec or to any other spec also give you a print out of before and after. If you cannot find a hunter machine then make sure its a 3d alignment. This is what I did and it stopped my tyre wear.
    I use a garage in Peterborough called Monarch Automotive after reading a good review on this forum worth a search for your local garage.

    Hope this helps

    JackS3
     
  3. Alex C

    Alex C Well-Known Member VCDS Map User Audi S3

    3,267
    360
    83
    negative camber or toe in?
     
  4. S3quatt

    S3quatt Flat Oot like a ducks Foot VCDS Map User

    652
    60
    28
    That would be negative camber or toe out...

    Any chance its lowered without adjustable tie bars?
    Maybe a broken spring on one side if it isnt...
     
  5. Prawn

    Prawn My other car is a MINI!!!!

    11,539
    3,494
    113
    guys,

    Marty has a golf, the rear is 100% non adjuatable.

    Marty: I'd get yourself down to a tracking place, and have the back end checked out. If it's within factory specs it shouldn't wear. Perhaps your beam is a bit out....
     
  6. Paradox1

    Paradox1 Well-Known Member

    1,833
    88
    48
    Sorry its a golf as prawns said.

    I got it aligned a few months ago and I'm beginning to wonder what was actually done as im sure its been there a while? I'll get the a different garage to check over it,new tyres while in at it.

    Thanks
     
  7. Grale1

    Grale1 Active Member

    795
    44
    28
    Paradox did you get to the bottom of your tyre wear? I've just notice mine is wearing on osr inner edge, not to sure what step to take next
     

Share This Page