1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Injector seat change

Discussion in 'A3/S3 Forum (8L Chassis)' started by QuestMS, Apr 1, 2014.

  1. QuestMS

    QuestMS Member

    Joined:
    Jun 23, 2013
    Messages:
    67
    Likes Received:
    4
    Sorry if this has been covered already but I couldn't find the answers I needed...

    I have new injector seats to go in an inlet manifold I just had aqua blasted, I need to know what sealant I should use when fitting. I have some of the Mac tools threadlocker which is oil tolerant but not sure if its the right stuff for the job.

    What thread locker or sealant have people used when replacing these injector seats?

    Thanks in advance

    J
     
  2. Advert Guest Advertisement


  3. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow...
    Staff Member Moderator Audi S3

    Joined:
    Sep 14, 2008
    Messages:
    20,281
    Likes Received:
    3,474
    I have used silicon sealant on mine... little bit in the threads and all good..

    <tuffty/>
     
  4. QuestMS

    QuestMS Member

    Joined:
    Jun 23, 2013
    Messages:
    67
    Likes Received:
    4
    Cheers buddy
     

Share This Page