1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  1. G60DAN

    G60DAN Member

    383
    4
    18
    Hello all

    Right I'm getting an error code 65535 from my haldex had a look at the plugs and there fine put a new earth strap on and still get the code. Now what I would like to know is there any coming back from this[TABLE="class: page, width: 100%, align: center"]
    [TR]
    [TD][TABLE="class: tborder, width: 100%, align: center"]
    [TR]
    [TD="class: alt1, bgcolor: #FFFFFF"]Internal Control Module memory error or do I need a new one.

    Thanks for any help
    [/TD]
    [/TR]
    [/TABLE]

    [/TD]
    [/TR]
    [/TABLE]
     
  2. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow... Staff Member Moderator Audi S3

    21,685
    4,114
    113
    65535 - Ross-Tech Wiki

    What makes you think its the Haldex? most of the info I have seen suggests the ECU and check sum errors?

    What module did you scan? have you got the output of the scan from VCDS to post up?

    <tuffty/>
     
  3. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow... Staff Member Moderator Audi S3

    21,685
    4,114
    113
    Controller may be to blame if its coming from the AWD module...

    <tuffty/>
     
  4. G60DAN

    G60DAN Member

    383
    4
    18
    It was AWD module that was scanned.
     
  5. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow... Staff Member Moderator Audi S3

    21,685
    4,114
    113
    Controller issue then by the sounds...

    <tuffty/>
     
  6. G60DAN

    G60DAN Member

    383
    4
    18
    Right got the print out

    Address 22 AWD Labels 02D-900-554.1b1
    Part no: 02D 900 554 B
    Component Heldex LSC ECC. 0006
    1 Fault Found
    65535 Internal Control Module Memory Error
    00-00
     
  7. <tuffty/>

    <tuffty/> Badger 5 Edition...Its all about the flow... Staff Member Moderator Audi S3

    21,685
    4,114
    113
    That fault code is associated with checksum errors... maybe water in the controller or something... you may be able to remove the controller and take it apart to clean it/dry it/resolder joints etc...

    <tuffty/>
     
  8. G60DAN

    G60DAN Member

    383
    4
    18
    Thanks Tuffty will have a look at the weekend and pull it apart and see if it's wet in side.
     

Share This Page