1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Finally an S3 owner

Discussion in 'The Welcome Section' started by rosscopeeco13, Nov 30, 2013.

  1. rosscopeeco13
    Offline

    rosscopeeco13 Member

    Joined:
    Nov 15, 2013
    Messages:
    56
    Likes Received:
    6
    [Nov 30, 2013]
    photo.jpg photo 2.jpg Hi again , well have finally purchased a Dolphin Grey S3 02 plate S3, I pick it up on Tuesday has a few modificatios remapped to 275 full milltek inc down pipe cold air induciotn kit , 93k full audi history until 83 the private after that very happy can't wait to get back on dry land to drive it as I'm currently still stuck offshore.

    Attached Files:

    Last edited: Nov 30, 2013
    #1
  2. Ads

    Ads

    [Dec 28, 2014]

  3. rosscopeeco13
    Offline

    rosscopeeco13 Member

    Joined:
    Nov 15, 2013
    Messages:
    56
    Likes Received:
    6
    [Nov 30, 2013]
    Sorry about the photos will get the hang of uploading them soon lol
    #2
    Sandra likes this.
  4. Sandra
    Offline

    Sandra MODERATOR Staff Member Moderator

    Joined:
    Sep 12, 2010
    Messages:
    17,042
    Likes Received:
    2,694
    [Nov 30, 2013]
    Nice car, i will rotate them round tmrw when im On my laptop. Hope you enjoy the car. :) x
    Last edited: Nov 30, 2013
    #3
  5. rosscopeeco13
    Offline

    rosscopeeco13 Member

    Joined:
    Nov 15, 2013
    Messages:
    56
    Likes Received:
    6
    [Nov 30, 2013]
    Thanks Sandra, I hope I do enjoy it I'm sure I will .
    #4
  6. rosscopeeco13
    Offline

    rosscopeeco13 Member

    Joined:
    Nov 15, 2013
    Messages:
    56
    Likes Received:
    6
    [Dec 3, 2013]
    after sifting thru thru the mountain of paperwork that come with my car i have found out it has various poly bushes fitted a badger tip in red , full milltek cat back non resonated system, remapped to 275bhp, k and n induction kit, all receipts and paperwork to back up purchasing and fitting so very happy , apart from the boost gauge on the dash , so could be looking to mount a single pillar gauge pod or put the gauge in the air vent anyone fitted either or both in the past? Also I'm from Dundee where would be the nearest place for me to get the haldex serviced as it was done 15k ago and will need done in the future,
    #5
  7. S3_Jacko
    Offline

    S3_Jacko Well-Known Member

    Joined:
    Jul 16, 2010
    Messages:
    1,469
    Likes Received:
    393
    [Dec 3, 2013]
    Welcome to the site buddy.. car looks good..This is more a generic hello section.. Your best asking all your questions and introducing yourself again over on the 8L section, loads of boys that know their stuff on there


    Have a look at the Scotland forum aswell from time to time... just type (scotland in the search bar) news on upcoming meets and the likes.. might get to see your car in person :thumbsup:
    #6
  8. S3_Jacko
    Offline

    S3_Jacko Well-Known Member

    Joined:
    Jul 16, 2010
    Messages:
    1,469
    Likes Received:
    393
    [Dec 3, 2013]
    Perth Audi, not too far away from you eh?
    #7
  9. rosscopeeco13
    Offline

    rosscopeeco13 Member

    Joined:
    Nov 15, 2013
    Messages:
    56
    Likes Received:
    6
    [Dec 3, 2013]
    There is an audi dealership in dundee but just wondered if there was another audi specialist but dundee audi will be my first choice
    #8
  10. S3_Jacko
    Offline

    S3_Jacko Well-Known Member

    Joined:
    Jul 16, 2010
    Messages:
    1,469
    Likes Received:
    393
    [Dec 3, 2013]
    Aye right, no up there too often nowadays and for some reason I thought Audi only had 4 dealerships in Scotland ahh well..

    getting confused with the lomond Audi group though
    #9
  11. rosscopeeco13
    Offline

    rosscopeeco13 Member

    Joined:
    Nov 15, 2013
    Messages:
    56
    Likes Received:
    6
    [Dec 3, 2013]
    Cheers anyway mate
    #10

Share This Page