1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

fault code about MAF

Discussion in 'VCDS (formerly VAG-COM) forum' started by outlaw, May 7, 2007.

  1. outlaw
    Offline

    outlaw New Member

    Joined:
    Nov 2, 2006
    Messages:
    14
    Likes Received:
    0
    hello ,
    i have a problem with MAF.i've upgraded my turbo and i used 3" intake pipe.i replaced the MAF(but i 've not upgraded the software yet).when i started the car ,it was not working properly.it always having a tendency to stop.i connected vag-com and checked if there was a fault code.and vag-com found a fault code which is : 16486 - mass air flow sensor (G70): Signal too low

    what could be the problem ? i thought the problem could be the software.because the software was made for the old turbo and old 2" intake pipe and maf can't read properly...or do you have any ideas ?
    #1
  2. Sebastian
    Offline

    Sebastian Member

    Joined:
    Aug 7, 2006
    Messages:
    286
    Likes Received:
    0

Share This Page