1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

exhaust heat shield

jezzy Sep 10, 2012

  1. jezzy

    jezzy Member

    768
    16
    18
    im just stripping the parts of the head to fit xs mani, now the heat shield that attaches to the head, there a 3 bolts, one by the turbo undone and out, the second in the middle will not move anymore, it seems its trapped on the manifold and wont move, the third one is just spinning. any ideas?
    any hints would be grate fully accepted.
    thanks
     
  2. Greg-S3

    Greg-S3 Active Member

    540
    53
    28
    You could try knocking the heads of the bolts? Angle drill and drill the heads off?
     
  3. Westy

    Westy Well-Known Member

    17,443
    1,103
    113
    I was unable to refit that heat shield to my AEB head so left it off. Apparently the earlier heads never had them.
     

Share This Page