1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ECU codes.

Discussion in 'RS4 Forum (B5 and B7 Chassis)' started by Robharr7, May 2, 2013.

  1. Robharr7
    Offline

    Robharr7 New Member

    Joined:
    May 2, 2013
    Messages:
    1
    Likes Received:
    0
    I have a 2007 RS4 Avant with a complete miltek exhaust system, including 100 cell racing cats. I brought the car like this. It has all of the correct engine mapping within the ECU's, as I have had this re-mapped myself. I have had problems in the past with fault codes pointing to lambda sensors, which turned out to be the inlet manifold. However, I am now getting the emission warning light illuminating at various times. The fault codes I am getting are, P2097, post catalyst fuel trim system to rich, bank 1, and on separate occasions, P2098, post catalyst fuel trim system to lean bank 2. I know this is a long shot, but can anyone advise. Thanks.
    #1
  2. SUBSEADESIGNER
    Offline

    SUBSEADESIGNER New Member

    Joined:
    Dec 27, 2012
    Messages:
    20
    Likes Received:
    1
    on a v8 bank1 is where cylinder 1 is so looking front front bank 1 on the left so bank 2 on the right yes?????? this not a statement but a question please
    #2

Share This Page