1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cup & coin holder removal

drewbee Apr 2, 2010

  1. drewbee

    drewbee Member

    196
    0
    16
    my cup holder seems to be broken, doenst hold a drink in it, and the coin holder doesnt seem to be be spring loaded, when you pull it out, it slides itself back in.

    want to replace these items, and idea where i can get new ones and how to fit?

    oh and it was like that when i got it. not my fault LOL

    many thanks :noway:
     
  2. chrisash32

    chrisash32 Member

    573
    1
    18
    haha! i spent 3hrs sat in the car working this out last night as i want to install an iphone dock into my coin tray!

    pull off the top surround above the cup / coin holder. then if you get a small flat head screw driver you should see on top of the cup holder there are two little square cut outs right at the edge in the plastic.. push down with the screw drivers and pull on the cup holder at the same time and it should release.. repeat this for each section and all should pull out!
     
  3. mattyboyc

    mattyboyc B6 Veteran Audi A4 Audi Avant Owner Group TDi

    1,995
    217
    63
    As above but you also need to pull the stereo foward about 50mm ( well you do in a avant ) as for where to get them, uaual places ebay-ebay-de, but get illuminated ones and do the mod, if yours dosen't already have it.
     
  4. iyrix

    iyrix Member

    460
    12
    18
    Will the iphone dock actually fit in there? I didn't think of that!
     
  5. A4 nut

    A4 nut Member

    351
    0
    16
    Cabs are different they have a compartment above the coin/cup holders dont no how to get out, but do no that there are 2 different thickness so when you buy one make sure you buy the cab ones(there thicker) unless you can take the front off them and switch round
     
  6. chrisash32

    chrisash32 Member

    573
    1
    18
    well i got a cheap one off eBay as it needed trimming slightly to fit, but it did fit quite snug once in...
    However, it didn't last too long as a roundabout simulation would have meant my iPhone would have been somewhere in the passenger foot well.. So back to the drawing board!
     

Share This Page