1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Could I use this clutch/flywheel combo on my S3 8L?

Discussion in 'A3/S3 Forum (8L Chassis)' started by Routledge, Nov 21, 2011.

  1. Routledge
    Offline

    Routledge Wind Deflector Trend-setter

    Joined:
    Nov 7, 2011
    Messages:
    395
    Likes Received:
    10
    [Nov 21, 2011]
    #1
  2. Ads

    Ads

    [Sep 30, 2014]

  3. <tuffty/>
    Offline

    <tuffty/> Badger 5 Edition Staff Member Moderator

    Joined:
    Sep 14, 2008
    Messages:
    15,981
    Likes Received:
    1,364
    [Nov 21, 2011]
    Its a smaller clutch than the S3 one so hardly and upgrade... std (LuK) clutch was about £100 from GSF... dual mass more expensive of course but have seen a lot of probs with mismatched clutch and SMF combos... typically the clutch biting point ends up in the floor....

    I am not even sure its suitable for the 6 speed boxes anyway...

    <tuffty/>
    #2
  4. Routledge
    Offline

    Routledge Wind Deflector Trend-setter

    Joined:
    Nov 7, 2011
    Messages:
    395
    Likes Received:
    10
    [Nov 21, 2011]
    Okay - I am trying to reduce the bill if possible as at the moment for a Sachs clutch, LuK DMF & release bearing incl. VAT i'm looking at £477.98 - That one at £150 saved me over £300!
    #3
  5. Routledge
    Offline

    Routledge Wind Deflector Trend-setter

    Joined:
    Nov 7, 2011
    Messages:
    395
    Likes Received:
    10
    [Nov 21, 2011]
    #4
  6. <tuffty/>
    Offline

    <tuffty/> Badger 5 Edition Staff Member Moderator

    Joined:
    Sep 14, 2008
    Messages:
    15,981
    Likes Received:
    1,364
    [Nov 21, 2011]
    Again...A3 is 228mm and S3 is 240mm...

    <tuffty/>
    #5

Share This Page