1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Correct front roll bar?

Discussion in 'A4/A4 cabriolet/S4 forum(B6 chassis)' started by Andie0, May 1, 2013.

  1. Andie0
    Offline

    Andie0 Member

    Joined:
    Aug 28, 2012
    Messages:
    491
    Likes Received:
    13
    Hi peeps, i replaced my drop links and control arms the other week and noticed while with the mechanic that the roll bar at each end was threaded and the bolt screws into the end of it, well when i bought the parts audi gave me a tec drawing of the suspension set up and it shows that the bolt goes through a brqcket which then has a nut attached to the back of it and not threading into the roll bar itself! Does this mean i have a dodgy aftermarket roll bar or was there a change in design at some point?

    just want to no as if this is a dodgy roll bar i want to replace it for a genuine one
    #1
  2. swarcup
    Offline

    swarcup Well-Known Member

    Joined:
    Sep 9, 2009
    Messages:
    1,287
    Likes Received:
    37
    sounds normal to me. mines the same
    #2
  3. Andie0
    Offline

    Andie0 Member

    Joined:
    Aug 28, 2012
    Messages:
    491
    Likes Received:
    13
    Weird how there tech drawings show different type of roll bar
    #3

Share This Page