1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Can some one please help?

Discussion in 'A4/A4 cabriolet/S4 forum(B6 chassis)' started by TURBOTRONICS, Aug 21, 2010.

  1. TURBOTRONICS
    Offline

    TURBOTRONICS Member

    Joined:
    Jun 8, 2009
    Messages:
    187
    Likes Received:
    0
    [Aug 21, 2010]
    I just don’t seem to have any luck me at all
    I was out earlier in my b6 s4 when it suddenly seemed to drop a cylinder or at least that what it felt like and a light came on on the dash
    Its been having what felt like a hesitation for some time now gradually getting worse until today
    Now iv noticed that 5 out of the 8 cols have been changed so im assuming this is a common fault on them
    So I decided to take the old looking ones out to see if it was possible to see any faults but dip **** me pulled on some coolant piping to pull it out the way and snapped one of the adapters covering me and the car in hot coolant
    Iv tried to fined some where to get a replacement but failed

    Can any one please tell me where besides audi I might get one of these adapters ( its as you look under the bonnet on the left hand side under the air intake 2 big pipes and one small one )
    And would a coil give the above problems?
    The coil only seemed to play up when its was hot

    Please help
    #1
  2. Ads

    Ads

    [Sep 19, 2014]

  3. AudiiduA
    Offline

    AudiiduA Member

    Joined:
    Feb 23, 2010
    Messages:
    359
    Likes Received:
    1
    [Aug 21, 2010]
    Coil packs are common, and will trow up a light on dash! need to get it on a vagcom if possible! the plastic pipe bit may have to be Audi only?? or try halfords or most other motor factors! hope you get it sorted?? somebody on here may be local to you with vagcom??? ask...
    #2
  4. TURBOTRONICS
    Offline

    TURBOTRONICS Member

    Joined:
    Jun 8, 2009
    Messages:
    187
    Likes Received:
    0
    [Aug 21, 2010]
    i think i need to get it on a vag com make sure its not a crank position sensor
    any one in the wigan area whith one who could help please
    #3

Share This Page