1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cam shaft position sensor fault????

jay1 Mar 2, 2013

  1. jay1

    jay1 Member

    Messages:
    168
    Likes Received:
    7
    Trophy Points:
    18
    Hi recently my car has been making a loud clicking noise under acceleration since I did a 30 min track day at silverstone now seems down on power so I scanned it and got the code 17746 camshaft position sensor g40 open or short to plus. Ticks over fine when I googled it a lot of the results were saying I the cam could have jumped a tooth? If so what do I need to do new timing belt or have it adjusted? Also will it do any more damage if I still drive it. Also I have just checked the cam belt briefly and does not seem lose as if a tensioner has gone or anything
     
    Last edited: Mar 2, 2013

Share This Page