1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Bumper/Headlight Adjustment - how flush is your car front?

Discussion in 'Audi S4/A4/A4 Cab (B7 Chassis)' started by Wrath, Apr 23, 2010.

  1. Wrath
    Offline

    Wrath Well-Known Member

    Joined:
    Apr 7, 2009
    Messages:
    1,190
    Likes Received:
    41
    [Apr 23, 2010]
    After finally getting my bumper->bonnet gap corrected, I noticed that my headlights don't sit flush, the bonnet extends over the top of them and the curved bit stands slightly proud of the bumper. Which part of the light is meant to dip below the bumper?

    I've now found out that the lights have adjusters as well but wondered if I should just leave alone or whether there is a method to get all corrected.

    I'm just concerned that after removing the bumper (again!!!!!), if I fiddle with the headlight adjusters then the bumper will have a gap again.

    S'ppose at the moment I can remove my headlights without the bumper :)

    Any experienced bumper/headlight adjusters anywhere?
    #1

Share This Page