1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

B6 S4 badge removal

BillTheButcher Mar 10, 2010

  1. BillTheButcher

    BillTheButcher Member Audi RS3

    170
    24
    18
    Hello. :)

    How are the front grille and rear S4 badges attached on the B6 S4? I'm guessing glue for the rear badge but is the one on the grille secured by pins through a backplate?

    TIA. :icon_thumright:
     
  2. rjm180

    rjm180 Active Member

    581
    34
    28
    Hi,

    I'm fairly sure the front grill has about 3 torx screws on the top which need to be removed. You can then remove the whole grill. The badge is pushed on from the front and held by a sort of a spring clip at the back which attaches the badge to one of the horizontal slats of the grill. Easy to remove.
    Hope this helps.
     
  3. BillTheButcher

    BillTheButcher Member Audi RS3

    170
    24
    18
    Thanks a lot. Very helpful. :icon_thumright:
     
  4. pjmspeedy

    pjmspeedy Dude, what's mine say ?

    1,058
    1
    36
    Easy way for removing the rear is to get some dental floss behind and pull
     
  5. BillTheButcher

    BillTheButcher Member Audi RS3

    170
    24
    18
    I did something similar with a previous car but I used high tensile fishing line and then a pencil rubber to get the remainder of the glue off.
     
  6. JimLoskot

    JimLoskot Member

    160
    2
    18
    also use a hair dryer to soften the glue
     
  7. A4 nut

    A4 nut Member

    351
    0
    16
    WD40 softens the adhisive without damaging the paint, spray it on and leave a couple of minutes use soft cloth and rub off the glue.
     

Share This Page