Just want abit of advice really logged my requested and actual boost and at 6370rpm this was in fourth gear full throttle, request boost pressure was 2.4bar and actual boost pressure was 2.1 bar.
So far I have checked maf voltages, n75 solenoid valve resistance (32 ohms) got my hand on the actuator and the rod feels tight and also have had a smoke test done. The smoke test didn't being up any leaks.
I have checked for codes and there aren't any on my car.
I have a stage 1 revo remap on an audi s3 facelift, green cotton air filter and forge 008 recirculating valve.
Is a 300mbar difference normal?
Has anyone got any other ideas of what else it could be?
Thanks in advance
So far I have checked maf voltages, n75 solenoid valve resistance (32 ohms) got my hand on the actuator and the rod feels tight and also have had a smoke test done. The smoke test didn't being up any leaks.
I have checked for codes and there aren't any on my car.
I have a stage 1 revo remap on an audi s3 facelift, green cotton air filter and forge 008 recirculating valve.
Is a 300mbar difference normal?
Has anyone got any other ideas of what else it could be?
Thanks in advance