vwnutant
Registered User
- Joined
- May 15, 2006
- Messages
- 86
- Reaction score
- 8
- Points
- 8
- Location
- manchester uk
- Website
- www.ukpassats.co.uk
After some help some of the below means nothing to me really !?....
Car- Audi a4 bfb 163bhp
remapped
k & n induction kit
rear boxes removed and new tailpipes
Five codes came up this evening - ( I did have the emissions light on presume that is lambda?)
AUDI A4 2003 BTB 163BHP ENGINE FAULT CODES –
DTC – SCAN
5 CODES FOUND 09/10/14
1) 17522-
17522
P1114
Heated oxygen sensor (HO2S) 2, bank 1 - heater resistance too high
Wiring, HO2S
2) 18010
18010
P1602
Engine control module (ECM) - supply voltage low from battery
Battery was disconnected, battery discharged, alternator, wiring open circuit, fuse
3) 16795-
16795
-
Secondary air injection (AIR) system - incorrect flow detected
AIR pump, AIR valve, AIR hose(s)
4) 18043
18043
P1635
CAN data bus, AC - no signal
AC control module trouble code(s) stored, wiring, matching resistor in ECM
5) 18058
18058
P1650
CAN data bus, instrumentation - no signal
Instrumentation control module trouble code(s) stored, wiring, matching resistor in ECM
Are the above common/anything to change/worry about ??
ive cleared the codes and will check again after work tomoz
Cheers
Ant
Car- Audi a4 bfb 163bhp
remapped
k & n induction kit
rear boxes removed and new tailpipes
Five codes came up this evening - ( I did have the emissions light on presume that is lambda?)
AUDI A4 2003 BTB 163BHP ENGINE FAULT CODES –
DTC – SCAN
5 CODES FOUND 09/10/14
1) 17522-
17522
P1114
Heated oxygen sensor (HO2S) 2, bank 1 - heater resistance too high
Wiring, HO2S
2) 18010
18010
P1602
Engine control module (ECM) - supply voltage low from battery
Battery was disconnected, battery discharged, alternator, wiring open circuit, fuse
3) 16795-
16795
-
Secondary air injection (AIR) system - incorrect flow detected
AIR pump, AIR valve, AIR hose(s)
4) 18043
18043
P1635
CAN data bus, AC - no signal
AC control module trouble code(s) stored, wiring, matching resistor in ECM
5) 18058
18058
P1650
CAN data bus, instrumentation - no signal
Instrumentation control module trouble code(s) stored, wiring, matching resistor in ECM
Are the above common/anything to change/worry about ??
ive cleared the codes and will check again after work tomoz
Cheers
Ant