1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Audi a3 rear LEDs and coding

Audi quattro Feb 5, 2014

  1. Audi quattro

    Audi quattro New Member

    17
    1
    1
    Just got it back after having the later led rears fitted to my car. My indicators flash red, I have a yellow light on permanently and the neon side light isn't on, they followed instructions but it does say will need coding after fitting
    Oh and no reverse, all bulbs are there they said

    The outer rings are not coming on, on sidelights.

    Btye 9 to Dec = 0 (mine says 00)
    Byte 10 to Dec = 0 (mine says 00)
    Byte 12 to Dec = 32
    Byte 19 Bit 2 Cold Diagnosis rear active (mine says be disabled)
    I am not sure what the 00 would do or the cold diagnostics rear active.
     
  2. WilkyA3

    WilkyA3 Active Member

    101
    28
    28
    Did you put the adaptors on the correct side? Or will they only go one way? Did you connect the outer ring wire to the number plate feed?
     
  3. Audi quattro

    Audi quattro New Member

    17
    1
    1
    It was fitted at garage and they said they followed the instructions, they said the lights need coding but I'm unsure how to go about it, surely I would see the outer ring lights
     
  4. WilkyA3

    WilkyA3 Active Member

    101
    28
    28
  5. southylad

    southylad Active Member

    544
    28
    28
  6. Audi quattro

    Audi quattro New Member

    17
    1
    1
    Hi mate took it for coding and they said they had no response, could the two adaptors be the wrong way round? Is there a left and right? As I just told the guy who fitted them for me he said they wer taped together but not labselled left or right, iv told him to start again and switch adaptors! Then il have to take it for coding again. I'm so close to giving up...
     
  7. WilkyA3

    WilkyA3 Active Member

    101
    28
    28
    Did you check the guide i posted above? That's is a brilliant guide and couldn't be more clear.
     
  8. Audi quattro

    Audi quattro New Member

    17
    1
    1
    Hi mate all sorted the adaptors wer the wrong way round, there are no faults or dash alerts do i still need them coding?
     
  9. discostu49

    discostu49 Active Member

    601
    132
    43
    Yes you will need them coded as your brake lights will be on permanently
     
  10. Audi quattro

    Audi quattro New Member

    17
    1
    1
    Yeh there are two red bulbs on Aswell as my outer neon light. This is not right is it, so the code I have seen on here should sort it all out yes?
     
  11. DriverN00B

    DriverN00B Active Member

    352
    34
    28
    That's right, if you use the code in the article link provided it'll sort it out.
     
  12. Audi quattro

    Audi quattro New Member

    17
    1
    1
    All sorted thanks alit they look great
     
  13. Audi quattro

    Audi quattro New Member

    17
    1
    1
    ImageUploadedByTapatalk1391700695.371587.jpg Thanks for all the advice and help they look great
     
    discostu49 likes this.
  14. Mindak

    Mindak Active Member

    805
    130
    43
    Just out of interest where did you get your lights mate?
     

Share This Page