Separate names with a comma.
Discussion in 'General Chat' started by ScottD3, Feb 17, 2011.
Best GIF Ever!!
lol I was just watching that. They move so fast!
open it up in a GIF editor.
Went to Costco's, saw this and thought of Westy.
A ceramic Freddo storage jar! Stood around 10-12" tall.
Joe that's amazing. What can be stored in it?
A couple of Freddo Chocolates I think! lol
How much are they? Might get one
Chocolate freddos, lol
Around a tenner I think, the head comes off, can't see you squeezing much more than a few Freddo chocolates through it to be honest, opening looked small. I nearly purchased it myself, the missus said no!
My colleague opposite me is going there this week. Expect to see a pic of Freddo on my desk by Friday
One for the footballers.
It was bloody cold this morning and I drove to work in my gloves.
I can honestly say I'm looking in to a heated steering wheel.
Tart or not.
I'd have warm hands.
such a bloody girl. Surprised you didn't wear your romper lol
That made me laugh Damo.
Anytime Sandra :thumbsup:
How you today much on??
Iv just got in had to treak out to shrewsbury to unplug a piece of equipment and plug it back in
I can't drive in it.
Not that I've tried or any thing
Scott's attempt at Yut speak goes horribly wrong.
Your 'speak yut' classes has been lacking alot recently.
yeah man i would give her '1' also
Never wanted to be a sticker more in my life chez
what a great arse!!
Morning pubbers, what tha know??
Horrible, wet, dank... That's all up here!! The octo tractor in for a service today and then over to be quoted on repair on the sill damage
Morning dude. I got to go clutch shopping
Sound expensive duder has it gone or going ?? What you going for??
It has been slightly slipping for about 6 months now since it was mapped to Revo stage 2 but now it's getting worse since turning up the timing at Bill's 2 weeks ago. I'm fitting large port head and rods at easter and there's no point me turning up my boost until the clutch is done now!
Just stuck a post in the 8L section seeking advice. I'll be pushing nearly 350lbft of torque so not sure if the standard clutch will cut it. I also need a new flywheel as that's never been done. Going to fit it all myself though to save a little bit of cash.
LNM FTW seen a few on the bay at weekend don't know if any good but not badly priced tho.
this any good to ya dude AUDI A3 S3 1.8T CARBON KEVLAR CLUTCH - NO RESERVE AUCTION!!! | eBay
Hope all is well.
Much happening in the world of the pub?
I'm home thinking what to do.
just sat in the office chatting to you mupets on the other side
Shhhh, guest list only
Wait... what??? You mean you guys talk on another site??
Has Scott shared his big news yet?
That he has a poor taste in cars and drinks far too much cider?
If so, then yes he has.
Yeah but they just past over it went off talking about houses. lol
Had about the same impact as your led light armrest then..
Yup, I need to finish that.
I might go fit some wheels, see what impact that gets.
what work is it you chaps do?
As little as possible.
I can 2nd that.