Arghhh more problems

[S10 AUD]

I've replaced my egr valve.. 1.9 130 pd avf engine.... But the turbo pipe will not fit back in so got a new silicon replacement elbow with metal coupling direct from audi and still that will not fit car has been on and off the road for months now please guys any ideas will be much appreciated. Is this a pressure fitting is there a special tool I need anything please

 

[Gazwould]

Replaced it with a new oem one ?

 

[pauldazzle]

Sounds like your replacement EGR isn't the correct type.
Post a photo of it.

 

[S10 AUD]

Dont think it is oem.. Got it from my local motor factors

 

[S10 AUD]

Its exactly th same as the wahler one that came off it

 

[Gazwould]

Why replace with new , an egr belongs in the bin .

 

[S10 AUD]

That may be true but replace like for like and you cant usually go wrong

 

[Greeny233]

It should be just a push in fitting with an o-ring and a clip to hold it in. I can't see how it won't fit.

 

[S10 AUD]

Defo wont fit in dude had many tries at it

 

[Mike.M]

Have you compared old and new very closly for differences.

Photos speak a thousand words!

 

[mattyb6]

How much was the piece of pipe mate?
The 90degree

 

[sumo]

Pull the clip up then grease the seal and push the pipe in the hole then push the clip down. Or post a pic to let us see.

 

[pauldazzle]

This is what you should have. Just push the pipe in until it clicks into place.

 

[S10 AUD]

How much was the piece of pipe mate?
The 90degree

28 Inc vat mate

 

[S10 AUD]

The id of the bore is smaller than the oem part getting it changed for the oem wahler part