1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Alloys

Discussion in 'A3/S3 Forum (8L Chassis)' started by Swornd, Sep 20, 2009.

  1. Swornd
    Offline

    Swornd Member

    Joined:
    Mar 31, 2009
    Messages:
    50
    Likes Received:
    0
    [Sep 20, 2009]
    #1
  2. Ads

    Ads

    [Sep 15, 2014]

  3. <tuffty/>
    Offline

    <tuffty/> Badger 5 Edition Staff Member Moderator

    Joined:
    Sep 14, 2008
    Messages:
    15,889
    Likes Received:
    1,318
    [Sep 20, 2009]
    Not with that offset or PCD... you should be looking for a PCD of 5x100 and offset of ET35... those are 5x112 and ET42

    <tuffty/>
    #2
  4. Dani_B19
    Offline

    Dani_B19 Audi-sports own special child.

    Joined:
    Nov 9, 2008
    Messages:
    7,280
    Likes Received:
    90
    [Sep 20, 2009]
    Paul what ET would you say would clear your new brake set up without useing spacers?
    #3
  5. <tuffty/>
    Offline

    <tuffty/> Badger 5 Edition Staff Member Moderator

    Joined:
    Sep 14, 2008
    Messages:
    15,889
    Likes Received:
    1,318
    [Sep 20, 2009]
    Dunno tbh... My ET33 RSTT wheels hit, my original 17" Avus's that are ET32 looked like they may clear by millimeters but I still wouldn't fit them without at least a 5mm spacer..

    The differences here though are more wheel design than offset... smaller offset should space the wheel out but would also depend on wheel width as to if it would fit under the arch... this may help...

    http://www.1010tires.com/WheelOffsetCalculator.asp

    Not sure if you can get aftermarket wheels with an ET of less than 35... not seen any personally...

    I posted a link to cheap spacers in my build thread... ESP Engineering IIRC...

    <tuffty/>
    #4
  6. Dani_B19
    Offline

    Dani_B19 Audi-sports own special child.

    Joined:
    Nov 9, 2008
    Messages:
    7,280
    Likes Received:
    90
    [Sep 20, 2009]
    Ill have a look into it, i just didnt want to add spacers, i know the unsprung weight will be minimal but still want to keep it to the minimum.
    #5

Share This Page