1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ABS bleeding

Discussion in 'VCDS (formerly VAG-COM) forum' started by A4 nut, Jan 29, 2012.

  1. A4 nut
    Offline

    A4 nut Member

    Joined:
    Nov 2, 2009
    Messages:
    351
    Likes Received:
    0
    Hi all how would i set the abs into bleed mode to get all the the air out the car is a 1995 audi coupe all input welcome
    #1
  2. Sandra
    Online

    Sandra MODERATOR Staff Member Moderator

    Joined:
    Sep 12, 2010
    Messages:
    15,986
    Likes Received:
    2,313
    You will probably get an answer quicker over in the section your car is, eg A3/A4 etc.
    #2
  3. A4 nut
    Offline

    A4 nut Member

    Joined:
    Nov 2, 2009
    Messages:
    351
    Likes Received:
    0
    It is really a vagcom question and im getting to old to wait for a answer in the classic section the last post there was 2 days ago
    #3
  4. Sandra
    Online

    Sandra MODERATOR Staff Member Moderator

    Joined:
    Sep 12, 2010
    Messages:
    15,986
    Likes Received:
    2,313
    Lol, was just a suggestion. Sorry.
    #4
  5. NHN
    Online

    NHN Modmetractor

    Joined:
    Jan 14, 2008
    Messages:
    27,263
    Likes Received:
    1,224
    If its fully registered cable, then contact RT for support.

    Also not sure the auto bleeding is supported that far back, again ask RT as they would know, if your cable/license is genuine that is.
    #5
  6. gen.heinz guderian
    Offline

    gen.heinz guderian Well-Known Member Regional Rep

    Joined:
    Jun 24, 2011
    Messages:
    1,359
    Likes Received:
    125
    Doubt you need vcds for that,just bleed them as normal.
    #6

Share This Page