1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

A4 Stereo Upgrade power loss

Markos Nov 1, 2006

  1. Markos

    Markos quattro'd up

    5
    0
    1
    Hi There,
    I have been searching threads to find an answer as to why after fitting a Becker HU in my 04 Avant the power cuts out after 1hr and turns the head unit off. Sure it's easy enough to turn it back on but that seems a bit harry/billy.
    Audi's electrical circuits seem to be a bit of a bone of contention.
    I would be very grateful of any input.
    Cheers:think:
     
  2. Broken Byzan

    Broken Byzan Photographic Moderator Staff Member Moderator VCDS Map User quattro Audi A4

    13,224
    464
    83
    \you need to swap the ignition wire and the permenant live over.The easy way to do this is to use an ISO cable with bullets on the red/yellow wires
     
  3. AndyMac

    AndyMac Moderator Staff Member Moderator

    9,833
    45
    38
    You'll probably find you don't even have an ignition on feed to it (so it shouldn't work at all). You need to mate the perm live with the ignition on from the HU and connect to the perm live on the ISO plug.
     
  4. Markos

    Markos quattro'd up

    5
    0
    1
    Cheers for the info, on closer inspection there was no ignition feed on the audi side of the ISO connecter. It's suprising the HU powered up at all but it must have been because of the perm connection.
    I ran in a fused ignition switch wire to power OEM amp and antenna amp previously so I wired into that.
    Its weird how these gremlins rear up as the ISO connecter was specificly for the Symphony 6cd double din.
    Still if it's not in the loom, it's gonna work strange.
    Thanks again
     

Share This Page