1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

2.5Tdi dash swap skc code needed!

Discussion in 'A6/S6/Allroad forum (C5 Chassis)' started by cheezeberger, Jan 6, 2009.

  1. cheezeberger
    Offline

    cheezeberger New Member

    Joined:
    Jan 6, 2009
    Messages:
    5
    Likes Received:
    0
    [Jan 6, 2009]
    I have a 2000 C5 2.5Tdi AFB, Dash was dying so got one from breaker with matching key. Cant access VDO C5Kombiinstrument with Vag Tacho says access denied. Need to get SKC to put in Vag Com to pair used Dash with engine ECU but think also need Deler code and date?? anyone used Vag login or anything to do this? or any hex readers and software to decode? finally I thought this was immo2 but extra field in vag com comes up with 17 X's then 14 digit immo id which looks like immo3?
    This is all just to see if my Fuel pump is really dead, so any advise welcomed (except burn it!):banghead:
    #1
  2. Ads

    Ads

    [Sep 22, 2014]

  3. TDI180
    Offline

    TDI180 New Member

    Joined:
    Jul 27, 2007
    Messages:
    15
    Likes Received:
    0
    [Jan 6, 2009]
    i read 4 digit pin with vag commander on an 03 allroad, no need for skc, where are you based?
    #2
  4. cheezeberger
    Offline

    cheezeberger New Member

    Joined:
    Jan 6, 2009
    Messages:
    5
    Likes Received:
    0
    [Jan 6, 2009]
    Thanks TDI180, i'm in cornwall so probably too far! I have been able to read plenty of other VAG group with my vag tacho but not this A6. Thought Vag Commander was only for CAN? reading around I gather vag com login is just 4 digit with a 0 infront?
    #3
  5. cheezeberger
    Offline

    cheezeberger New Member

    Joined:
    Jan 6, 2009
    Messages:
    5
    Likes Received:
    0
    [Jan 14, 2009]
    Got hold of vag commander, read code login with vag com now connected fine. just got to buy an injection pump now!
    #4

Share This Page