hello,
i have a no start problem,
i cant hear the fuel pump when i open the switch. i changed fuel pump still no change.
i got 8 error codes:
8 Faults Found:
18044 - Powertrain Data Bus
P1636 - 35-00 - Missing Message from Airbag Controller
18089 - Control Module Programming Not Finished...
hello,
i drove my car on first gear up to 5k rpm and left off the gas, after that i cant engage any gear but i can start the car on first gear and when i press the clutch its keep driving.
what can be the problem?
hello,
i want to change my old rusty turbo oil feed to a new oil feed.
i looking for easy to install oil feed..
what the size of the line that will fit?
and what end fitting size at turbo side and filter side?
thanks !
hello
i changed the clutch on my A3
after i finished i drove the car and noticed that 2nd and 4th gears not going in.
some one told me that my cable is bended.
is this true?
hello
i changed my clutch yesterday to new LUK kit.
now i can shift to 3rd and 4th gears only, the other gears not shifting at all.
maybe i need to adjust the cable?
hello
i have A3 manual transmission
yesterday i drove the highway and suddenly i hear noise from the transmission sound like when you shift to reverse.
after that i slowly drove the car and after i put some more gas the rev goes up and the car not moves.
now i can shift to any gear without the...
hello
my right trasmittion mount snapped and the engine fall down to the right.
as well the driver side axle is broken now and the car cant move.
what should i replace to fix it?
hello
the kilometer counter in the cluster is stopped working.
its always show 0 and total kilometer stay the same and not going up.
what can cause this problem?
hello,
i changed my cylinder head and connected everything back to its place.
after i started the car its idle ok and when i shift to any gear and let go the cluth i hear bad grinding noise and the car shakes.
what can cause this issue and how should i fix it?
hello,
i have boost problem, the car is mapped to 1.3bar and i am boosting only 1 bar.
i tryed to unplug the n75 connector and i am boosting on 0.3bar
i tryed to take off the hose that going to the actuator and its still boosting on 1 bar.
tested maf readings 150 g/s on 6600 rpm.
what can be...
hello
yasterday i did compression test to the engine, i found that i have low compression in all 4 cyl.
i got about 50PSI dry and 75PSI wet
what can cause this low compression ?
CYL 1:
CYL 2:
CYL 3:
CYL 4:
my idle probe volts is too low and i am running too rich?
what can cause that?
checked air mess its 3g/s
Marker
TIME
Group 7 - Field 1
STAMP
Probe volts - 0-1V
V
0
0.16
0.26
0.165
0.53
0.205
0.8
0.735
1.06
0.755
1.33
0.74
1.6
0.73
1.86
0.7
2.12...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.