thank you george for your reply and diagram. still not been able to see where this fits without tearing the car apart or ending up in traction.
further research indicates the part is not critical so i will reluctantly place in the glove box and hope my brake pedal doesnt fall off.
thanks again
hello all
have finally tracked down an annoying rattle in my recently acquired s3 8v and now am at a loss as to what this part is and its function.
it was behind the plastic panel by the drivers right knee,the one that covers the diagnostic port. have managed to undo the 2 bolts on the bottom...
hello all,
my new (to me) 2016 s3 8v has a post shutdown whirring and beeping noise. sound like something running for aprox 20 seconds,can anyone tell me what this is and is it normal. still learning about this car so expect more questions soon. thanks in advance
i had the same problem.....found it behind the cubby hole panel at the left hand rear of your boot....there is a screw fixing at the top which isnt obvious...undo and pull out the panel and the sticker is stuck inside...hope this helps.
due to the inability of a driver who chose to change lanes without using mirrors or indicators,my much loved s3 8p has been deemed a total loss and i am now looking for a replacement,probably an 8v.
my car was a manual but i am considering a dsg auto my only fear are the size of the bill if they...
as i have finally managed to clear enough space for another car in my garage i have finally started to put the s3
away at night and have noticed a low volume buzz coming from the bulkhead area after i switch off,continues for a couple of minutes then dissapears.its definitely electronic,a bit...
i had a similar issue on my s3 8p....changed the pcv valve which sorted it.
i didnt have any backfiring issues but the reving at idle sounds the same...someone on this site suggested a pcv prob so i took a punt and changed it,easy job and not expensive.
hello all,
my original 3 button key shell is getting really tatty so i purchased a replacement and cannot get the pcb out of my old casing as it seems to have special fastenings. i cannot find a small enough tool to unscrew these (tiny, like watch screws) and am having difficulty even telling...
one of my rear seat passengers has badly chipped the hard shell on the back of my wingbacks,it looks too big and deep to do any kind of touchup so i think it has to be totally resprayed.
can anyone tell me how to remove the shell from the seat...i cant see anything obvious but i will bet i am...
hi to all,
i would appreciate any feedback on a glitch in my 2010 s3 sportback which occured yesterday.
waiting to pick up some passengers and engine idling normally...then revs increased to aprox 1500 for a few seconds and dropped back....afew seconds later same thing..increased and dropped...
o.k. guys...thanks for your input......i will try a bit of rubber grease as i dont think engine oil will last very long.
will recheck in 6months and see if its still lubed.
hello all,
just about to fit a new gfb dv+ to my 2010 s3 and the fitting instructions as well as reading this forum recommends lubing the brass piston with engine oil on initial assembly,no problem but my question is ....is this oil going to last or will i have to do this again as a maintenance...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.